Introductory Offer! FREE SHIPPING on Clamps and Die Sets

Controls Weld Shrinkage Distortion

The Angle-Rite® clamping system controls weld shrinkage distortion by compensating during the welding process. The intersected tube retains its straightness or original curvature after welding. It helps you save time and wasted materials.

The picture to the right shows the difference between tubes welded with and without the Angle-Rite clamping system. The tube to the right of the straight edge was welded without the Angle-Rite clamping system. The tube to left was welded with the Angle-Rite clamping system. Notice how straight it is. That is the weld compensation at work.





Secures Joint for Welding

The unique interlocking design of the Angle-Rite® clamping system holds tube connections in place, allowing for a complete setup before committing to a design and welding. No second person is required and no other jigs are needed. For example, an entire railing system can be set up using the Angle-Rite clamping system before any welding is applied.

The 
Angle-Rite clamping system acts as a "third hand" and holds tube connections in place allowing the welder to use both hands for welding, thereby eliminating the need for an extra person or a makeshift setup to hold joints for welding. This picture shows a boat railing in place waiting for the initial tig weld.







Simplifies Set Up & Reduces Time and Waste

No more working in inclement weather, near flammable materials, or finished surfaces. The Angle-Rite®​ clamping system will help you retain control of the project. You can set up an entire railing; disconnect the interlocking primary and secondary clamps still attached to the tubes, and reassemble it all at a different location without losing any of your angles or alignments.  This allows moving the welding process indoors or to a safer location, away from flammable surroundings, dangers to the welder, or the surrounding personnel.

The Angle-Rite clamping system increases efficiency and reduces labor hours. It also increases safety by allowing the welder to have both hands available to complete the job. This is especially useful while working on stairways, boat decks, and other elevated surfaces. Note: This clamping feature is not intended to set up a temporary or permanent safety railing but rather is only intended to maintain alignment while fabricating the railing.




Easily Transfers Angles

The Angle-Rite® Clamp allows you to set angles visually, or if the intersecting angle between two tubes is known, simply dial-in the desired angle and lock it in place. Once your angle is set, the secondary clamp and tube are transferable between connections, cutting attachments, and other positions. Alternately, if you've changed your mind on the angle, you can dial-in a different angle, without losing your angle or alignment. This will save you time and money.


Click here to download our latest brochure.